MacDon R116, Инструкции по разгрузке и сборке

Страница: 140 / 234

214713
132
Revision A
7.6 Checking Disc Mower Float
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1004134
Figure 7.9: Disc Mower Centered behind the
Tractor
1. Center the disc mower directly behind the tractor.
2. Lower the disc mower to the ground.
3. Shut down the tractor, and remove key from ignition.
4. Grasp the front corner of the disc mower and lift; the
weight should feel approximately like 45 kg (100 lb.) at
both ends. If adjustment is required, refer to
7.6.1
Adjusting Disc Mower Float, page 132 .
7.6.1 Adjusting Disc Mower Float
The float setting (or lifting force) changes depending on the conditioner type and options. The setting must be equal
at both ends of the disc mower.
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
NOTE:
Changes to the disc mower operating position can affect the float settings. After adjusting the cutting height or the
cutting angle, check float and adjust as necessary.
1004134
Figure 7.10: Disc Mower Centered behind
Tractor
1. Center the disc mower directly behind the tractor and
set the cutterbar to an orientation and tilt appropriate for
the crop type and cutting conditions. Refer to the disc
mowers operator
’
s manual for the cutterbar angle
adjustment.
PERFORMING PREDELIVERY CHECKS