215333
85
Revision A
1004134
Figure 3.101: Rotary Disc Pull-Type Centered behind
Tractor
1.
Center the rotary disc pull-type directly behind the tractor
and set the cutterbar to an appropriate orientation and tilt
for the crop type and cutting conditions. Refer to
Adjusting Cutterbar Angle, page 90
for instructions.
NOTE:
Ensure skid shoes are in correct position before setting
rotary disc pull-type angle, float, and tilt.
2.
Raise the header fully.
3.
Shut down the engine, and remove the key from
the ignition.
1030284
A
Figure 3.102: Cylinder Lock-Out Valve
–
Closed
Position
4.
Close the rotary disc pull-type
’
s lift cylinder lock-out
valve (A) on each lift cylinder by turning the handle to the
horizontal position (90° to the hose). Repeat on
opposite side.
1030275
A
B
C
Figure 3.103: Float Spring
–
Right Side
5.
Loosen retaining bolt (A) and rotate cover plate (B) away
from float spring bolt (C). Repeat on opposite side.
6.
Fully loosen float spring bolt (C). Repeat on opposite side.
