215333
86
Revision A
1030285
A
B
Figure 3.104: Adjuster Bolt
7.
Turn adjuster bolt (A) to achieve the recommended
measurement (B) for the conditioner type. Refer to
Table
for measurements.
NOTE:
Float settings indicated in the table are starting points only.
Float force should still be checked with the rotary disc pull-
type float and cutting angle set as planned for use in
the field.
•
Turn bolt clockwise (towards spring) to increase float.
•
Turn bolt counterclockwise (away from spring) to
decrease float.
Repeat on opposite side.
Table 3.9 Float Setting Starting Point
Model
Conditioner
Type
Length of Exposed Thread
None
280
–
290 mm (11
–
11 5/32 in.)
R113 PT
Roll
120
–
130 mm (4 3/4
–
5 1/8 in.)
Finger
Right: 145
–
155 mm (5 3/4
–
6 1/8 in.)
Finger
Left: 15
–
125 mm (4 1/2
–
4 15/16 in.)
None
230
–
240 mm (9
–
9 1/2 in.)
R116 PT
Roll
70
–
80 mm (2 3/4
–
3 1/8 in.)
Finger
Right: 95
–
105 mm (3 3/4
–
4 1/8 in.)
Finger
Left: 65
–
75 mm (2 1/2
–
3 in.)
1030279
A
B
Figure 3.105: Adjuster Bolt Cover Plate
8.
Reposition cover plate (A) over float spring adjuster bolt as
shown. Secure cover plate (A) by tightening bolt (B). Repeat
on opposite side.
