215333
88
Revision A
Adjusting Cutting Height
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage lift cylinder lock-out valves before going under machine for any reason.
NOTE:
There are two skid shoes on the R113 PT, and four on the R116 PT.
1021275
A
B
C
D
C
D
Figure 3.107: Skid Shoes
–
R113 PT
1.
Raise the rotary disc pull-type fully.
2.
Shut down the engine, and remove the key from the
ignition.
3.
Engage the lift cylinder lock-out valves. For instructions,
refer to
4.
Loosen bolts (C).
5.
Remove bolts, nuts, and washers (D).
6.
Raise or lower the skid shoe.
NOTE:
Skid shoes have two adjustment settings: fully raised (A)
and fully lowered (B).
7.
Install bolts, nuts, and washers (D), and then tighten.
8.
Tighten bolts (C).
9.
Adjust the cutterbar angle to the desired working position.
If the angle is not critical, set it to the mid-position. For
instructions, refer to
3.15.3 Adjusting Cutterbar Angle, page
.
10. Check the rotary disc pull-type float. For instructions, refer
to
.
