215333
275
Revision A
4.7
Electrical System
4.7.1
Maintaining Electrical System
•
Use electrical tape and cable ties as required to prevent the wiring harness from dragging or rubbing.
•
Keep lights clean and replace defective bulbs.
4.7.2
Servicing Amber Hazard/Signal Lights
Replacing Amber Hazard/Signal Bulb
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Lower the rotary disc pull-type fully.
2.
Shut down the engine, and remove the key from the ignition.
1010531
A
Figure 4.314: Plastic Lens and Screws
3.
Remove two Phillips screws (A) from the fixture, and
remove the plastic lens.
4.
Replace the bulb (trade #1157), and reinstall the plastic lens
and screws.
Replacing Amber Hazard/Signal Light Fixture
1010533
B
A
Figure 4.315: Amber Hazard Light and Mounting
Bracket
1.
Cut cable ties (A) securing harness covering to light.
2.
Retrieve connections from inside harness covering
(approximately 150 mm [6 in.] from light) and disconnect
wires (not shown). If necessary, remove tape.
3.
Remove four nuts (B) (only 3 shown) securing light to
bracket, and remove light. Pull wires through hole in
bracket.
4.
Feed connectors of new light (not shown) through hole in
bracket, and position light onto bracket.
5.
Install four nuts (B) and tighten.
6.
Connect wires to connectors in harness, and secure harness
covering with tape and cable ties (A) as required.
