215333
270
Revision A
Adding Lubricant to the Header Swivel Gearbox and Hitch Swivel Gearbox
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
NOTE:
This procedure is the same for both header swivel and hitch swivel gearboxes and , and must be done on both upper and
lower gearboxes.
1.
Shut down the engine, and remove the key from
the ignition.
1004107
A
B
Figure 4.304: Swivel Gearbox
2.
Clean the area around check plug (A) and breather/filler
plug (B).
3.
Remove check plug (A) and breather/filler plug (B).
4.
Ensure the lubricant level is visible or begins to drain
through check port (A), and add gear lubricant to gearbox
through port (B) as required. Refer to this manual
’
s inside
back cover for a list of recommended fluids, lubricants, and
capacities.
5.
Reinstall check plug (A) and breather/filler plug (B), and
tighten.
4.5.14
Wheels and Tires
Checking Wheel Bolts
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
IMPORTANT:
Check and tighten field wheel bolts and transport system wheel bolts (if installed) after the first hour of operation and
every 100 hours thereafter.
