![background image](http://html.mh-extra.com/html/macdon/m155-2022/m155-2022_operators-manual_685745223.webp)
215676
203
Revision A
The header angle can be adjusted from the cab without shutting down the windrower when the windrower is equipped
with the hydraulic center-link. The windrower
’
s cab display module (CDM) allows you to establish preset header angle
settings for a variety of crop conditions.
IMPORTANT:
•
Changing the header angle will affect the float slightly, due to the changes in weight distribution. If the float setting is
changed, the header angle setting may also need to be adjusted.
•
To prevent damage to the knife guards when conditions are not suited to operating with a heavier float setting (for
example, when harvesting in a rocky or a wet field), do
NOT
use the windrower
’
s TILT CONTROL function. Instead, use
the HEADER HEIGHT switch.
1000738
A
B
C
D
E
Figure 4.86: Operator Console
A - Program Button
B - Display
C - Header Tilt Down
D - Header Tilt Up
E - Display Selector
Hydraulic link (optional)
To adjust the header angle:
•
To decrease the header angle, press HEADER TILT UP switch (D) on the ground speed lever (GSL) handle. The CDM will
display a reading on the lower line, which should be a decreasing value ranging between 00.0 and 10.0.
•
To increase the header angle, operate HEADER TILT DOWN switch (C) on the GSL handle. The CDM will display a
reading on the lower line, which should be an increasing value ranging between 00.0 and 10.0.
NOTE:
The HEADER TILT switch can be locked out to prevent inadvertent changes to the header angle. For instructions, refer to
Activating Header Tilt Control Lockout, page 109
.
Mechanical link
Adjust header angle as follows:
Содержание M155 2022
