![background image](http://html.mh-extra.com/html/macdon/m155-2022/m155-2022_operators-manual_685745117.webp)
215676
97
Revision A
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.88: CDM Programming Buttons
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear.
1009098
RETURN TO CUT MODE
CXXX
MXXX
HEIGHT & TILT
D
C
B
A
Figure 3.89: Return to Cut Mode
4.
Press SELECT (D) until RETURN TO CUT MODE? appears on
the upper line.
•
HEIGHT & TILT or HEIGHT ONLY will appear on the
lower line.
5.
Press left arrow (B) or right arrow (C) to select RETURN TO
CUT MODE. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
Setting Auto Raise Height
Enabling the auto raise height feature in the cab display module (CDM) allows the Operator to raise the header to a preset
height by quickly pressing the HEADER UP switch on the ground speed lever (GSL) twice. It can be enabled by accessing the
AUTO RAISE HEIGHT sub-menu in the WINDROWER SETUP MENU in the CDM.
For more information on the Auto Raise Height feature, refer to
4.4.8 Auto Raise Height, page 208
.
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
Содержание M155 2022
