![background image](http://html.mh-extra.com/html/macdon/fd75/fd75_operators-manual_685691484.webp)
214323
466
Revision B
1001596
A
Figure 6.233: Double-Reel Header
1022425
A
B
Figure 6.234: Measurement Locations
A - Clearance Points
B - Flex Points
11. Measure clearance at ends (A) of each reel and at flex
locations (B).
NOTE:
The reel is factory-set to provide more clearance at center
of reel than at ends (frown) to compensate for reel flexing.
1020906
X
D
C
Figure 6.235: Reel Clearance
12. Check finger clearance (X) when positioned between
locations (C) and (D). Depending on the reel fore-aft
position, the minimum clearance can result at the guard
tine, hold-down, or cutterbar. For finger clearance
measurements, refer to Table
.
13. Adjust the reel if necessary. For instructions, refer to
Adjusting Reel Clearance, page 467
.
Содержание FD75
