37
MBCP33-4
In
more
detail
. . .
3. Form a loop at the middle of the line and insert this loop into the hook on the
spool (Fig. 29).
4.
Wind the two parts of the cutting line clockwise firmly around the spool (Fig. 30).
5. Place the spool into the spool assembly and pass each end of the cutting line
through the respective holes.
6. Pull both ends of the cutting line so there is 15 cm of loose cutting lines.
30
29
WARNING!
After changing the cutting line, run the machine under no load
for at least a minute to make sure that the line was installed properly and the
machine operates correctly.
WARNING!
Never use steel threads or cutting lines!
NOTE:
To keep the cutting line elastic, remove the trimmer head (23) and store
it in a damp place. Two or three days before the start of the new season, place
the cutting line in water to keep it flexible.
Care and maintenance
