1
Operating Instructions
When leaving the premises, the system must be Armed. However, before doing so, check that all
windows are closed and locked, all protected doors are closed and PIR Detectors are not obstructed.
Ensure that pets are restricted to areas not protected by PIR Detectors.
The system has armed modes, Instant-Arm and Delay-Arm.
Instant-Arm mode will immediately Arm the system. Once the system is Armed, activating any
detector (i.e. Opening a door/windows protected by a Magnetic Contact Detector or moving into
a PIR protected area), will immediately trigger an Alarm.
On returning to and entering the property the system must be Disarmed before opening any
protected door or entering an area protected by a PIR Detector otherwise an Alarm will occur. For
this reason when using Instant-Arm mode, the system should be Armed and Disarmed from outside
the property using the Remote Control.
Delay-Arm mode will Arm the system with a 15 second entry/exit delay. On arming the system in
Delay-Mode the siren will beep once and then again after the 15 second delay has expired. This
allows time for you to leave the property before the system becomes fully Armed. On returning to
and entering the property by opening a protected door or moving through a PIR protected area the
system will be triggered and the Siren will emit a single long beep. However, an Alarm will not sound
until the 15 second delay has expired. The system must be Disarmed using the Remote Control
during the 15 second delay period in order to prevent the Alarm from sounding.
If an Alarm occurs the Siren will sound continuously until the set alarm duration time expires. The
alarm will then stop and the system will automatically re-arm itself. This process can be repeated
up to 3 times after which time the ‘Alarm Lockout’ feature will operate and prevent the system from
re-arming.
Notes: To conserve power and maximise battery life the PIR Detector will only detect movement if
there has been no movement detected within the previous minutes.
Arming the System
ARM
The system can be set in ARM mode using the Remote Control as follows:
Remote Control:
Press the
button.
The Siren will acknowledge the signal by beeping once.
DELAY-ARM
The system can be set in delay-arm mode using the Remote Control as follows:
Remote Control:
Press the
button.
The Siren will acknowledge the signal by beeping once and then again after the 15 second
entry/exit period has expired. The system will not be fully Armed and active until after the second
beep.
