18
Important:
Ensure that the rear tamper switch is closed when you fit the siren cover to the back
plate (i.e. listen for the switch to click). If the switch does not close this will prevent the Solar Siren
from operating correctly.
4. The fitting of the Solar Siren is now complete.
Siren Service Mode
In order to remove the Siren from the wall to change the batteries, it is necessary to place the Siren
into Service Mode to prevent the Tamper protection switch on the Siren operating and triggering an
alarm.
The Siren can be switched into Service Mode using the Remote Control as follows:
Remote Control:
Press and hold the
button for 6 seconds.
The Siren will produce short beeps as the button is pressed followed by a single long beep 6
seconds later to indicate it has switched into Service Mode.
Siren Operating Mode
When you have completed any alterations to the system remember to switch the Siren back into
Operating Mode.
The Siren can be switched into Operating Mode using the Remote Control as follows:
Remote Control:
Press and hold the
button for 6 seconds.
After 6 seconds the Siren will produce a single long beep to indicate that it has switched into
Operating Mode in a Disarmed state. The button should be released during or immediately after
the long beep, otherwise the system will Arm.
