Lucent Technologies PortMaster, Руководство по настройке

Страница: 246 / 364

Configuration Steps for an Office-to-Office Connection
15-10 PortMaster Configuration Guide
Configuring a Dial-In User
A user account must be set up on the PortMaster in Paris so the Office Router in the
London can dial in when traffic is queued. The new user
london should be configured
with the values shown in Table 15-8.
After you configure the user table as shown in Table 15-8, enter the following command
to save the configuration:
Command> save all
For more information about configuring user table settings, refer to Chapter 7,
“Configuring Dial-In Users.”
Table 15-8 User Table Values
Setting Command
Username add netuser london
Password set user london password anypasswd
Protocol set user london protocol ppp
User IP address set user london destination 192.168.200.1
Netmask set user london netmask 255.255.255.0
IPX network set user london ipxnet F2
(When configuring the IPX network number for the dial-in user,
you must set a number that is different from the one on the
Ethernet at either end.)
RIP routing set user london rip on
MTU set user london mtu 1500
Compression set user london compression on