Lucent Technologies PortMaster, Руководство по настройке

Страница: 215 / 364

Using Frame Relay 13-9
Configuration Steps for a Frame Relay Connection
For more information on Ethernet parameters, refer to Chapter 4, “Configuring the
Ethernet Interface.”
Configuring Synchronous WAN Port Parameters
Configure the synchronous WAN port W1 to the values shown in Table 13-3.
After you configure the synchronous WAN port as shown in Table 13-3, enter the
following commands to reset the port and save the configuration:
Command> reset w1
Command> save all
For more information on synchronous ports, refer to Chapter 6, “Configuring a
Synchronous WAN Port.”
Configuring the PortMaster in New York
Configure the settings for the PortMaster in New York with the values in the following
sections. You do not need to specify a gateway for the PortMaster in New York because
it is on the Internet.
Table 13-3
Synchronous WAN Port Values
Setting Command
Port type set
w1
network
hardwired
Protocol set
w1
protocol
frame
Port IP address set
w1
address
192.168.20.1
Netmask set
w1
netmask
255.255.255.0
Modem control set
w1
cd on
RIP routing set
w1
rip
broadcast
Annex-D set
w1
annex-d
10
(LMI can be used instead of Annex-D.)
DLCI list set w1 dlci 16:192.168.20.2
(You do not need to set a DLCI list if the remote router supports
Inverse ARP.)