Lucent Technologies PortMaster, Руководство по настройке

Страница: 95 / 364

Configuring an Asynchronous Port 5-19
Configuring a Port for Network Access
To set a port for network two-way access, use the following commands
Command> set S0 network twoway
Command> save all
PPP and SLIP Connections
The Serial Line Internet Protocol (SLIP) is an older protocol than PPP and not as robust.
However, some hosts support only SLIP. The type of protocol allowed is specified for
each dial-in user, dial-out location, or network hardwired port.
PPP is a method of encapsulating network layer IP protocol information on
asynchronous point-to-point links. PPP is described in RFC 1331 and RFC 1332. Lucent’s
implementation of PPP provides PPP autodetection support for the Challenge Handshake
Authentication Protocol (CHAP) and Password Authentication Protocol (PAP) on serial
ports running PPP. ComOS 3.3 and later releases support Multilink PPP as described in
RFC 1717 on ISDN BRI ports, and all ports on the PortMaster 3.
Note – Be sure to use the set S0 rts/cts command to enable hardware flow control
(RTS/CTS) for all SLIP and PPP connections.
PAP and CHAP Authentication
PAP and CHAP authentication occur in the following sequence:
1. A user dials in to a port and starts sending PPP packets.
2. The PortMaster negotiates the authentication protocol with the remote host.
3. If the host refuses PAP authentication, the PortMaster prompts the host to
authenticate using CHAP. If the host refuses CHAP authentication, the PortMaster
hangs up.
Both the local communications server and the remote device must support CHAP to use
this protocol.
To configure PAP or CHAP for PPP users, the local user table or RADIUS must have an
entry for each authorized user that includes the username and password. The passwords
on both ends of the connection must be identical or the authentication process fails.
To disallow PAP authentication and accept only CHAP, enter the following command:
Command> set pap off
✍