Lucent Technologies PortMaster, Руководство по настройке

Страница: 242 / 364

Configuration Steps for an Office-to-Office Connection
15-6 PortMaster Configuration Guide
After you configure the port as shown in Table 15-3, enter the following commands to
reset the port and save the configuration:
Command> reset s1
Command> save all
For more information about asynchronous ports, refer to Chapter 5, “Configuring an
Asynchronous Port.” For more information about configuring modems, refer to Chapter
10, “Using Modems.”
Dial-In User Settings for London
You must set up a user account on the Office Router in the London office so the
PortMaster 2 in the Paris office can dial in when traffic is queued at the main office. The
new user
paris
should be configured with the values shown in Table 15-4.
After you configure the user table as shown in Table 15-4, enter the following command
to save the configuration:
Command> save all
For more information about configuring user table settings, refer to Chapter 7,
“Configuring Dial-In Users.”
Table 15-4 User Table Values
Setting Command
Username add netuser paris
Password set user paris password anypasswd
Protocol set user paris protocol ppp
User IP address set user paris destination 192.168.1.1
Netmask set user paris netmask 255.255.255.0
IPX network number set user paris ipxnet F2
RIP routing set user paris rip on
MTU set user paris mtu 1500
Compression set user paris compression on