Lucent Technologies PortMaster, Руководство по настройке

Страница: 61 / 364

Configuring Global Settings 3-23
Displaying the Routing Table
Viewing SNMP Settings
Settings for SNMP monitoring, read and write community strings, and read and write
hosts are stored in the SNMP table.
To display the SNMP table, enter the following command:
Command> show table snmp
Monitoring SNMP Alarms
When an interface or modem fails, the SNMP agent traps the error message generated
by the failure and sends it to the SNMP Manager.
To view the status of failed modems or interfaces from the command line interface,
enter the following command:
Command> show alarm
The output of this command lists alarm messages and associated alarm identification
numbers. For details about a specific alarm, enter the following command:
Command> show alarm [alarm-id]
To clear alarms from the SNMP alarm table, enter the following command:
Command> clear alarm alarm-id | all
Refer to the PortMaster Command Line Reference for more information.
Displaying the Routing Table
Use the following command to display the IP routing table entries:
Command> show routes [ String | Prefix/NM ]
You can replace
String
with ospf or bgp to display only OSPF or BGP routes. Replacing
Prefix
/
NM
with an IP address prefix and netmask displays only routes to that destination.
Enter the IP address prefix in dotted decimal format and the netmask as a number from
1 to 32, preceded by a slash—for example, /24. The netmask indicates the number of
high-order bits in the IP prefix.