Lucent Technologies PortMaster, Руководство по настройке

Страница: 198 / 364

ISDN BRI Unnumbered IP Configuration Example
12-14 PortMaster Configuration Guide
After you configure the user table as shown in Table 12-6, enter the following command
to save the configuration:
Command> save all
For more information about configuring user table parameters, refer to Chapter 7,
“Configuring Dial-In Users.”
Configuring a Dial-Out Location
A location entry on the PortMaster in Denver must be created for the location identified
as
sf . This allows the PortMaster router in Denver to call the PortMaster in San
Francisco when network traffic is queued. The new location sf should be configured
with the values shown in Table 12-7.
User IP address set user sf address 192.168.100.1
Netmask set user sf netmask 255.255.255.0
IPX network set user
sf
ipxnet
F3
RIP routing set user
sf
rip on
MTU set user
sf
mtu
1500
Compression set user
sf
compression on
Table 12-7 Location Table Values
Setting Command
Location name add location sf
Type set location sf manual
(Set the location for manual dialing until after the
configuration has been tested. Once the configuration is
verified, change the connection type to on-demand.)
Protocol set location
sf
protocol
ppp
IP destination set location
sf
destination
192.168.100.1
Netmask set location
sf
netmask
255.255.255.0
Table 12-6 User Table Values (Continued)
Setting Command