Line Assignment (#301)
Description
This System Programming procedure assigns the outside lines that are available
at an extension. The default order of line assignment to the buttons on a system
phone is from left to right, starting in the bottom left corner (see Figure 5-1 on the
next page). To put the lines in a different order, first use this procedure to
remove all assigned lines; then assign lines in the desired order.
Related Features
can be used only during initial system setup to
assign a subset of lines to all extensions. You can use Line Assignment to
assign additional lines to specific extensions. For example, if five lines were
assigned to all extensions using Number of Lines (#104) and there are eight
lines in the system, use Line Assignment (#301) to assign lines 6, 7, and 8 to
specific extensions.
After you finish Line Assignment, you can use
each outside line assigned to an extension should start ringing. If you add a
line to the system, its factory setting is Immediate Ring.
to determine the order in which the
system selects a line for an extension when the user at that extension lifts
the handset or turn on the speaker to make a call. If you add a line to the
system, it becomes the last line in the selection sequence.
and
extensions to prevent calls from being made or received on them.
If you want to prevent a user at an extension from accessing a line, make
sure you restrict the line for that extension using
even if the line is not assigned to that extension, so it cannot be
accessed using
The user must have access to an outside line in order to dial numbers on the
Emergency Phone Number List (#406)
Considerations
A line must be assigned to a button with lights. If a line is assigned to a
button
without lights, you cannot access that line, nor can you program
anything else on the button.
You can assign multiple lines (up to 15) to a standard phone, but a
single-line phone can handle only one call at a time. To make a call, a user
lifts the handset and dials 9 at the intercom dial tone; the system selects the
first available line based on the Automatic Line Selection programmed for
the extension. (Alternatively, the user can use Direct Line Pickup to access
a specific line.)
5-110
Line Assignment (#301)
Содержание PARTNER Advanced Communications System Release 1.0
Страница 6: ...iv...
