Clarity
LX600
Operator Manual
Page 37
monitors are used then the higher resolution monitor should be connected to the “Video
Out 1” connector. If these recommendations are not observed, then it is possible that
some of an external monitors display will spill over onto the encoder wheel touch screen
display.
See section 35 (LX Tools) for details on how to setup the external monitors.
6.2.6
USB
Four USB connectors are provided for connecting a keyboard, mouse or memory device (or
charging your phone). Single USB connectors are also provided on the front panel below the
power switch and inside the keyboard drawer.
6.2.7
MIDI
MIDI In, MIDI Thru and MIDI Out connectors are provided.
See section 30 for details on the LX300’s MIDI functions.
6.2.8
SPMTE Timecode
A female 3 pin XLR socket is provided for SMPTE Timecode input.
6.2.9
Audio In/Out
Two XLR connectors are provided for audio input and two for audio output.
An “Audio Out” 3.5mm headphone socket is located inside the keyboard drawer.
See section 24.7 for details on Audio playback.
6.2.10
LED Desk Lamps
Two 3 pin XLR connectors are provided for LED desk lamps. Each connector provides 12volts
power for a LED. Pins 1 and 2 are ground and pin 3 is +12 Volts.
The brightness of the LED desk light can be controlled from the “LX Tools” utility.
See section 35 for details on LX Tools.
6.2.11
External Inputs
The “external Inputs” 9-pin D-SUB connector on the rear can be used to connect up to 6
external push buttons that act the same way as the “Go” buttons on the playbacks. The
connector is wired to accept 6 inputs in the form of contact closures.
The pin assignments on the 9 pin D-SUB connector are:
Pin Button Playback
1
Go 10
2
Go 11
3
Go 12
4
Go 13
5
Go 14
6
Go 15
9
Common
To remotely operate a Go button, provide a contact closure (short circuit) from its control pin to
the common pin.
6.2.12
Reset
The
Reset
button should only be used if instructed by LSC technical support. The LX600 GUI
(Graphical User Interface) can be reset from the LX tools utility. See section 35
Pin 9
Pin 1
Circuit to operate button playback 10
