Clarity
Programmer
Operator Manual
Page 139
Set the Preferences in the Show Menu to "Restore Playback State".
Activate the cue and save the show.
Whenever you load the show this cue will automatically run and stay on for the duration of the
show.
21.12
UNIVERSAL CONTROL PANEL
The bottom of the screen contains the Universal Control Panel which has generic controls for
Intensity, Position, Colour and Beam. These controls work with any type of fixture that has
been selected and are especially useful to simultaneously control selections of mixed fixture
types.
Clicking and dragging in these controls uses low mouse gearing for accurate control, but can be
made even finer by holding down [Shift].
In the
Intensity
box you can click on a preset value (0, 25, 50, 75 or 100%, Closed or
Open) or drag in the
Dimmer
or
Strobe
areas.
In the
Position
box you can drag to vary pan and tilt.
In the
Colour
box you can drag to vary the colour. If the fixture only has limited colour
selections (not full colour mixing) available, these will be indicated by small dotted
boxes. Click on (or near) a box to select that colour.
In the
Beam
box, you can drag to vary iris, focus and zoom. If the fixture has specific
gobos, click on the gobo or
Open Gobo
to select it.
21.13
ATTRIBUTE CONTROLS
The area below each attributes name is known as an Attribute Control.
The individual attribute values can be varied by dragging with the mouse in their respective
area. You can also hold [Shift] when dragging for finer control.
In this example, the intensity of 5 fixtures has been dragged to 80%.
21.13.1
Attribute Quick Menus
The name of each Attribute Control can be clicked or the Attribute Control itself right-clicked to
access the attribute quick menus. These menus provide rapid access to common attribute
settings. Specific menus are available for each individual attribute.
Intensity Attribute
Control
Tilt
Attribute
Control
