Clarity
Control Booth
Operator Manual
Page 155
You can manually change the length by entering a length value in the form “bars.beats”.
For example: 2.0 for 2 bars duration.
The
X
button returns the length to the automatically calculated value.
For more information see “Metronome” in section 26.6 “Performance Window”.
24.2.3
Cue-list Priority Settings
Priority
. Default value = 0. When fixtures are being controlled by multiple cue-lists, attributes
are normally controlled on a LTP (Latest Takes Precedence) basis. However, you can override
the LTP action by entering a priority value for each cue-list. Higher numbers have priority over
lower numbers. The value can be set as a positive or negative number (+150 to -150).
Preset values for priority can be easily applied by clicking:
Prog
Sets LTP priority to Programmer (100)
High
Sets LTP priority to High (50).
Normal
Sets No LTP priority (0).
Low
Sets LTP priority to Low (-50).
Manually setting a priority higher than 100 prevents a Programmer grabbing control of the
fixtures in the cue-list.
24.3
PLAYBACK CONTROL PANEL
Clicking on a cue-list allows you to control it from the Control panel.
The
I
(Intensity) fader controls the overall intensity of the fixtures in the cue-list.
The
Mnl
(Manual) fader controls the overall level of
all attribute
values
in the cue-list.
It is normally set at full, but can be used to manually fade the entire cue-list in and out.
>
(Go) Plays the next cue in the cue-list or restarts a paused fade. Pressing
>
will start
the fade to the next cue even if the current fade has not finished.
II<
Pauses any fades in progress. If no fades are in progress, if fades back to the
previous cue.
>>
Snaps to the next cue in the cue-list, ignoring all times.
<<
Snaps to the previous cue in the cue-list, ignoring all times.
Jump
Allows you to jump out of order and fade directly to any cue that you select in the
cue-list. Select the cue by clicking on it then press the
Jump
button to perform the
jump.
Inhibit
. If Inhibit is active (green), no output from the selected cue-list is permitted
and an X is displayed beside the cue-list name. This setting is retained by the cue-list
until “Inhibit” is de-selected.
Release
. Releases the cue-list from the output.
If the cue contains any dynamics then the
Fx Rate/Amp
controls become active and
can be used to vary the dynamics by either entering a value in their respective boxes,
clicking the up and down arrows or by moving the wheel which provides smooth variable
control.
Intensity Fader
Manual Fader
Rate & Amplitude
controls for any FX
(dynamics) in the
cue
Reset
