Chapter 6. Function Description (I/O)
Proc PID Dis
Operating reference
CON_20
Multi-function input signal
ON
OFF
ON
Disable
Disable
Terminal
OFF
Enable
Disable
Enable
Enable
Disable
Disable
Disable
Disable
1.19) Timer Input
The multi-function input terminals P1~P7 can generate the timer output based on the timer ON delay time at I/O_55
and timer Off delay time at I/O_56. The following example is the case where I/O_05 is set to timer input and the multi-
function output terminal AX1 at I/O_41 is set to ‘Timer Out’.
Code
LCD display
Description
Setting
range
Unit
Setting value
I/O_05
P5 Define
Multi-function input terminal P5
Define
Timer Input
I/O_41
AX1 Define
Multi-function output terminal AX1
Define
Timer Out
I/O_55
TimerOn Dly Timer On Delay Time
0.1 ~ 3600.0
sec
I/O_56
TimerOff Dly Timer Off Delay Time
0.1 ~ 3600.0
sec
1.20) SoftStartCncl (Soft Start Cancel)
Soft start cancel is used when the shortest acceleration/deceleration time is required without using the existing
accel/decel time. In this case, real acceleration/deceleration time depends on the load condition and response
characteristic of speed controller. The following table shows what kind of acceleration/deceleration time is used when
P1, P2 and P3 are used for the transfer of accel/decel time or soft start cancel function is enabled.
I/O_55
I/O_56
Multi-function input
terminal P5
Multi-function output
Terminal AX1
Timer ON delay time
Timer OFF delay time
ON
ON
OFF
OFF
OFF
OFF