LS tractor XP8084, Руководство оператора, Страница: 226 / 288

5 - 38
(4) Replacing Fuel filter cartridge
Fuel pre-filter
Main fuel filter
water sensor
(3) Changing Transmission oil

Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm
oil and lower implements and stop the engine.

Set container under the drain plug and remove
drain plug under the transmission and drain oil
completely.

Clean metal powder stuck to the drain plug and
tighten drain plug again with cooper washer.

Add new oil until the oil level is between “Min”
and “Max” of the oil gauge.

For oil specification and capacity, see chapter 5-
3, “Lubricants and Capacity” or the last page in
this manual.
Oil filling inlet
Drain plug
▶
The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling inlet and then open the cap.
Caution
▶
Do not throw the exhausted waste fuel to any place. This may pollute the soil and
water seriously and also is prohibited legally. If violating, you would be responsible
for that by civil or criminal case. The waste fuel must be disposed according to the
environment laws.
Caution
▶
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel
system component that will be disconnected. Fit a suitable cover disconnected fuel
system component. Do not fill the new filter with fuel. Invisible fine contaminants
can enter the injection pump and it may cause damage to the fuel injection system.
Caution
①
Main fuel filter

Apply parking brake and set a container under
the main fuel filter.

Turn the filter counter-clockwise to remove with
using a filter wrench.

Coat the seal of new filter with a little fuel.

Assemble new filter.

Bleed the air from the main fuel filter. (Refer to
the chapter 5-13, “General maintenance” in this
manual.)