23
Using the Setup Menu
Screen
Use the Screen menu to set resolutions, turn
the channel border on/off, adjust the main
display position, and set the dwell time for Auto
Sequence Mode..
Figure 14.0 Screen menu
To configure screen settings:
1. From the Setup Menu, select
Screen
and
press
. The Screen menu opens.
2. Select
Border
and press
to select
On
/
Off
. If On, a white border appears in
Quad mode dividing the quadrants of the
main display screen.
3. Select
Video Adjustment
and press
.
The menu disappears. Press
to
adjust the vertical and horizontal position
of the main display.
4. Select
Auto Switching
and press
to
set the dwell time for Auto Sequence
mode from
1~10 seconds
or
Off
. The
higher the time, the longer the single
channel will remain on-screen during Auto
Sequence mode.
5. Select
Resolution
and press
to set
the display resolution at
640x480
,
800x600
,
1024x768
(default), or
1280x1024
.
6. Press
until the Exit menu appears.
Select
Save & Exit
and press
to
save your settings.
Audio
Use the Audio menu to enable/disable audio
recording, change audio input/output volume,
and enable/disable mute.
Figure 15.0 Audio menu
To configure audio settings:
1. From the Setup Menu, select
Audio
and
press
. The Audio menu opens.
2. Select
Record
and press
to turn
audio recording
On
/
Off
.
Note:
If audio recording is enabled, you
must
connect line-in audio (RCA) to the
Audio-In port on the rear panel of the
system.
3. Select
Mute
and press
to Mute On/
Off. If off,
all
audio on the system will be
disabled (input and output).
4. Select
Input Volume
and press
to
increase/decrease the slider.
5. Select
Output Volume
and press
to
increase/decrease the slider.
6. Press
until the Exit menu appears.
Select
Save & Exit
and press
to
save your settings.