50
User manual
• Remove half of the tyre rim by levering a large flat screwdriver all around between the tyre skirt and the rim edge.
• Repeat the same operation for the other part of the rim.
• Remove the inner tube from the tyre casing.
• Repair the tube and put it in place or replace it, making sure that there is nothing that might pierce the tube in the tyre. (If
the old inner tube needs to be repaired and put back in place and if it has been wet during the repair, it is best to apply talc).
• Inflate the tube slightly and place it in the rim.
• Place the outer rim half on the tyre, being careful to pull the valve out of the hole provided for this purpose.
• Place the second rim half (sheeting) on the tyre, making sure to align the holes of the 4 screws indicated in
26
.
• Reassemble the wheel on the hub following the previous procedure.
• Inflate the tyre to the prescribed air pressure.
• Screw in the valve cap.
10.8. Battery replacement
Tools needed:
• A pair of pliers
• An 11” wrench
• 2 flat 10” wrenches
• 2 flat 17” wrenches
• 1 shim
• A 5 mm BTR wrench
• A 6 mm BTR wrench
• A 8 mm BTR wrench
• A torque wrench
10.8.1. Battery removal
• Disarm the circuit breaker
• On the Out-Chair L
, remove the two rear mudguards by unscrewing the mudguard screws.