6
User manual
2. Safety
2.1. Standards and guidelines
All safety information in this manual relates to the current French legislation and the provisions of the European Union. In other
countries, the relevant legislation and provisions must also be respected.
The Out Chair has been manufactured in accordance with current technical regulations for safe operation. The safety of the Out
Chair is certified by the CE marking, the declaration of conformity is certified according to EN 12184.
2.2. Declaration of conformity
As a manufacturer, Logo Silver declares under its own responsibility that the Out Chair complies with specifications 93/42 and
2007/47 relative to the European directives for medical devices.
The design, development and manufacture of the Out Chair are in full compliance with safety with the following technical
requirements:
Risk analysis and management according to NF EN ISO 14971 standards
Design requirements NF EN 12182 and NF EN 12184
Dynamic Stability, Static Stability, Fatigue Testing, Static load promotional literature, Use and Maintenance Guide, Labelling,
Determining Energy Consumption, Determining Speed, Acceleration and Deceleration, ability to climb the maximum safety
slope, ability to climb obstacles.
Compliance with the NF EN 12184 standard means among other things that the values required for an incline, an obstacle
crossing, and a speed are reached or exceeded by the Out Chair.
2.3. General safety instructions
•
The Out Chair can only be used in accordance with instructions.
•
Only duly informed and authorized persons can use the Out Chair.
•
Only one person at a time can travel in the Out Chair.
•
For safety reasons, it is imperative that the user always wears a helmet and fastens their seat belt.
•
All safety instructions contained in this operating manual and in all valid associated documents must be observed and
followed. This notice must be available to the user at all times.
•
The cushion and the backrest fabric are not easily flammable but can catch fire. The use of fire or a lit cigarette should
be exercised with extreme caution.
•
The mode and profile changes; outdoor, indoor, crossing, seat position, backrest, casters, footrest and low to high speed
must all be done at a standstill.
• Check that the motors are engaged to allow the wheelchair to activate.
•
Only the manufacturer’s original components or options may be used. The optional components must be mounted
exclusively by a technician authorised by Logo Silver. Failure to comply with this recommendation will result in loss of
warranty rights.
•
Do not use the wheelchair under the influence of alcohol, drugs or any other narcotics restricting your driving ability.
•
Use the seat belt, especially when you do not have sufficient back support, or when you are on uneven ground.
•
Do not lean forward, over the sides or over the top edge of the wheelchair, especially if the ground is sloping.
• To transfer, get as close as possible to the new seat.
•
Do not connect any electrical equipment to your wheelchair. Entrust any potential installation to your supplier.
•
This chair has several moving parts driven by powerful cylinders. Be careful that people around you do not get hurt. Be
careful in particular of children’s fingers, which may be crushed by the wheel lift system and seat tilt system.
•
Do not go out unaccompanied or without a means of reaching someone you trust for journeys in isolated areas or when
the weather conditions are very bad.