16
User manual
When you need to climb over slopes, ensure that they do not have an incline greater than those specified by the technical
features (see chapter 3. Technical Features). Make sure you are in a configuration that allows you to cross over these slopes
(sufficient grip, no obstacles greater than 4 cm on the slope ...). Do not attempt to turn around on a slope greater than that
of the maximum lateral slope as you could tip over sideways. If you cannot climb a slope, try as much as possible to reverse
perpendicular to it. Limit acceleration on slopes in order to keep momentum, if you do not have enough momentum, the
off-road profile will allow you to gain more. If you have the steering lock option, it is advisable you use it to keep the wheels
straight.
7.3. «Indoor» driving profile with casters option
This procedure should only be used if you need to release the casters for indoor use in order to have increased manoeuvrability
(increased turning radius).
Warning
Take account of the recommendations in part 2. Security.
Do not attempt to use the off-road driving or crossing profile when the casters are out.
Do not attempt to use the indoor driving profile when driving 4-wheel drive. The front wheels must be positioned straight when the
casters are pulled out, otherwise the engines and / or the front wheels will be damaged.
The maximum speed limits allowed to cross over an obstacle of 1 cm in the event of the use of the casters is 1.5 km/h.
Be careful not to cross over obstacles greater than 1 cm in height with the casters.
The casters are only intended for indoor use.
Make sure to have the incline of the seat as parallel to the ground as possible and the incline of the backrest as perpendicular to the
ground as possible when you are moving about.
Make sure to respect the technical features of the chair (see corresponding chapter).
The caster option allows you to switch from an outdoor chair to an indoor chair, as it allows you to switch from 4WD to 2WD by raising
the front wheels and decreasing the turning radius.
The procedure for the correct use of this option is as follows:
1.
Position the front wheels straight while moving forward slightly.
2.
If you have the steering lock it is advisable to use it to lock the front wheels straight.
3.
When at a standstill, select the casters option with the MODE button while moving the joystick right or left.
4.
Push the joystick forward until the casters have released completely.
5.
When the casters are out, the front wheels are raised a few centimetres, they can no longer rotate, and the
forward gear driving speed is limited to 2.5 km / h. If this is not the case, refer to section 10.5. Caster
(optional) Malfunction
6.
To use the casters, select the “indoor” driving profile, which is more suitable due to its increased rotation
speed.
7.
To return to 4-wheel drive, stop and select the wheel option with the MODE button by moving the joystick
to the right or left.
8.
Fully retract the casters by pulling the joystick towards you.
9.
The speed limit is now disabled, and the front wheels will once again be powered (4-wheel drive). If this is
not the case, refer to section 10.5. Caster (optional) malfunction.
10. You can now use the off-road or crossing profile suitable for 4WD.
7.4. Manual movement
The wheelchair motors are equipped with magnetic brakes that prevent the wheelchair from rolling on its own when it is at a
standstill. The engine brakes are automatically tightened when the joystick is in the neutral or “off” position.
To push the wheelchair, disengage the magnetic brakes.
A lever for disengaging the brakes of the rear wheels is located above the rear engines:
• When disengaged, the engine brakes are turned off. You must therefore be careful that the wheelchair does not move in an
uncontrolled manner if the ground slopes.
• Always remember to return the release levers to the «on» position after extensive use.
