37
User manual OUTCHAIR
09/2018
• Use the same process to teach multi-digit channels. You can choose to store specific channels instead of
numbers in your «Channel Selection» menu.
Enabling and disabling IR codes:
IR codes can be enabled or disabled using the «IR Set Up» menu.
• To deactivate an IR code, select the - key on the front panel of the CJSM2-BT. Deactivated IR codes are displayed with
an X next to the highlighted command.
• To activate an IR code, select the + key on the front panel of the CJSM2-BT. Active IR codes are displayed with a
check mark next to the highlighted command.
Deleting IR codes:
• To remove the infrared code from a command, highlight the specific command in the device menu and press the
right button. Then select the «Delete code» option (Figure 23).
• To delete all IR codes from a device, select «Delete All Codes». Then switch off then on the CJSM2-BT to make
sure it is working properly.
•
7.8.9. Locking the control system
The control system can be locked using a sequence of buttons on the numeric keypad or with a physical key. This will be
set at the factory.
• Keypad lock: When the control system is activated, hold the On / Off button down.
• After one second, the control system will beep. Release On / Off button.
• Shift the joystick forward until the control system emits a beep.
• Shift the joystick backwards until the control system emits a beep. Release the joystick, a long beep will sound.
• The wheelchair is now locked.
•
The following screen will be displayed next time the control system is started up.
• To unlock the wheelchair: If the control system is off, press the On / Off button.
• Shift the joystick forward until the control system emits a beep. Shift the joystick back until the control system emits a
beep. Release the joystick, a long beep will sound.
• The chair is now unlocked.
