LNS SERVO S3 T, Инструкция по эксплуатации

Страница: 67 / 120

CHAPTER 6: GENERAL DESCRIPTION 65
QUICK LOAD SERVO S3T
5.5. Loading of tubes
Standard pushers may be used for loading of tubes, provided that the inner diameter of the tubes is less
than the diameters of the pushers.
If not, there are two courses of action:
1. The first consists of manufacturing plugs
(A) and installing them behind the tubes
(B) .
To ensure that the plugs do not come
loose when the bar is rotating, it is
recommended that they are fitted with an
O-ring gasket. These plugs must be fitted
at the rear of each tube. They also
protect the bar feeder from contamination
from the lathe's cutting fluid.
2. The second consists of replacing the
pusher tip (C) with a special tip (D) with a
diameter of 130 mm (available for the ø
25 mm pusher only).
Pos. Item no. Description
D 021.11.104.130 130 mm disc
To enable it to penetrate the spindle (F) ,
the tip must be turned at a diameter 4
millimeters less than the spindle passage
(F) . The tip must be adapted before being
fitted on the pusher.
Procedure:
1.
Bar feeder in STOP position.
2.
Unscrew the threaded dowel (E) securing
the tip on the pusher.
3.
Remove the standard tip (C) .
4.
Install the special tip (D) , pushing it fully
into the pusher.
5.
Secure the tip with the retaining screw.