LNS SERVO S3 T, Инструкция по эксплуатации

Страница: 91 / 120

CHAPTER 7: OPERATION 89
QUICK LOAD SERVO S3T
4.2.3. Positions
End of bar position (may be not visible)
The end of bar position determines the moment when the bar feeder enters the loading cycle.
In principle, the end of bar position is adjusted as closely as possible behind the lathe's clamping unit
(approximately 5 mm) to ensure the shortest remnants.
Regardless of the length of the bars or parts, the end of bar position is always the same. In very special
cases, a different end of bar setting needs to be selected.
More information in section 6 of this chapter.
Top-cut position(may not be visible)
During feeding, the bar is inserted in the spindle and automatically positioned in the clamping unit of the
lathe.
This positioning corresponds to a value
(Z) programmed by the operator, which is equal to the distance
between the measuring cell and the position of the material in the lathe clamping device.
With this system, the setting is the same for any bar length.
More information in section 7 of this chapter.