LNS SERVO S3 T, Инструкция по эксплуатации

Страница: 28 / 120

26 CHAPTER 3: SYSTEM START UP
QUICK LOAD SERVO S3T
9.
Tighten the retaining screws (F) for the bearings (D) .
10. Slide the blades (K) underneath the rails, then screw the screws (L) until these are pushed
against the blades.
11. Install the loading table support (M) .
Install the bar magazine.
12. With the screws (J) , lift the bar feeder so that the base plate is 5 mm above the ground, then level
the bar feeder.
13. Tighten the screws (H) and (I) and the lock nuts (N) .
14. Install the non-return device (O) .
15. Couple the safety switch (SQ12) with the key (Q) which is located at the front of bar feeder rail,
then screw (R) the switch onto the retraction system. If the mounting holes for the switch are not
perfectly aligned, unscrew the retaining screws (S) for the security key, fit the switch then tighten
the screws once more. Attach the cable (A) with a flange (P) , so that it cannot come into contact
with other elements of the bar feeder when the latter is moved.
16.
Perform the alignment as indicated in Chapter 3.
Once the bar feeder is attached to the ground, check the alignment of the switch and the key by
moving the bar feeder then returning it to the working position.