LINK ELECTRIC & SAFETY CONTROL COMPANY OmniLink II, Руководство по эксплуатации

Страница: 26 / 81

April 27, 2004 Manual Version 1.01
4.5
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
PC STATUS
Counter OFF
TONNAGE
MONITOR
EXIT
0 0
READY TO STROKE
TOP
CHANGE
VIEW
FORWARD
TONNAGE
View
Peak
Reverse Tonnage
Total
7.3
Tons
150%
0%
CH1 - LEFT FRONT
REV LIMIT:
1.9
Tons
STATUS: OK
150%
0%
CH2 - RIGHT FRONT
REV LIMIT: 2.5
2.3
Tons
STATUS: OK
150%
0%
CH3 - LEFT REAR
REV LIMIT: 2.0
1.5
Tons
STATUS: OK
150%
0%
CH4 - RIGHT REAR
REV LIMIT: 2.0
1.7
Tons
STATUS: OK
Module Status: OK
CHANGE
REV LIMIT
2.4
REV LIMITS
ON/OFF
BYPASS
ON/OFF
RESET
ERROR
n
GRAPH CONFIGURE
AUTO-SETUP
Figure 4.4 shows a four channel screen when viewing reverse tonnages.
Notice that there are no limit bars when viewing reverse tonnage as there is only one reverse limit for
each channel. Referring to Figure 4.3, an additional setting in the reverse tonnage view is:
n) Reverse Limit Value - The reverse tonnage limit setting for this channel. Note that only
peak tonnage has a reverse limit.
Section 4.2.1 Selecting a View
As explained in section 3.2, data windows can monitor “local” peaks with a separate set of setpoints
from the “absolute” peak. Each set of tonnages and limits comprise a “view” in this screen and is
indicated by the box in the upper left of the screen as shown by “h” and “g” in Figure 4.2. The absolute
peak tonnages and associated limits are called the “peak view”. In all, there are six different “views” of
tonnages and settings - peak forward, peak reverse, data window 1 forward, data window 2 forward, data
window 3 forward, and data window 4 forward. The default view on entering the screen is peak forward
tonnages and settings.
Figure 4.4 - Example Peak Reverse Tonnage View