Lincoln Electric Growth Series, Инструкция по сборке

Страница: 53 / 94

Assembly Guide
43
Qty Part Description Part #
1 Assembled side and gantry
components
From Step B8
4 99R6 ball bearings TMS-432-0010-01
4
Screw, BSCS,
3
⁄
8
"
–
16 X 1
TMS-410-0218-16
4
Nut, Nylock,
3
⁄
8
"
–
16 steel, zinc-plated
TMS-414-0201-18
16 Washer, flat,
3
⁄
8
", steel, cadmium-
plated
TMS-413-0406-18
Step B9: Add underside bearings (optional)
Required parts /
components
Instructions
If a routing tool is mounted on the Torchmate 2x4 Growth Series CNC Cutting System table, you can help
prevent the gantry from being lifted from the rails during routing by installing underside roller bearings. The
top and side bearings are pre-installed on the gantry, but you must add the underside bearings for routing
configurations.
• For use in routing applications, assemble four roller bearings on the underside of the
gantry, two on each side. Each assembly includes: a button head screw, four washers, a
roller bearing, and a hex nut.
• Pass the screw through one washer, then through the gantry. On the inside of the gantry,
place two washers on the screw, followed by the bearing, another washer, and the hex nut.
• Position the roller bearings so that they make only light contact with the underside of the
rails when moved through the full gantry travel, and then tighten them fully.
Illustration
Underside
roller-bearing