Lincoln Electric Growth Series, Инструкция по сборке

Страница: 49 / 94

Assembly Guide
39
Step B5: Set the initial datum and log on to VMD
So that the VMD can begin communicating position information with the Accumove2, the first requirement is
to set the initial location as the machine's temporary datum. This will be reset to the actual machine datum
after the configuration file is loaded. The VMD software protects your machine setup and use by requiring a
user name and password to log on.
Qty Part Description Part #
1
Motor Cables
Ethernet
Crossover
Cable
Computer and Accumove2 with
crossover cable, and IP address
From Step B4
Required parts /
components
Instructions
User name /
password screens
• IMPORTANT : Never connect or disconnect a motor cable while the Accumove2 is powered on.
This will cause irreversible damage to the Accumove2.
• If you haven't powered on the Accumove2 and started the VMD software, perform these
steps. Until the Accumove2 completes its start up process, you may see a "Not Connected"
screen which should soon disappear.
• A notice box requests "Please switch the drives on." Click Hide . The drives are automatically
switched on when the table Datum is set in a later step.
• Click the Log On button to bring up the log on screen. Select the Admin user name and
enter the password for that name. When the Accumove2 is first powered up, the default
password for the Admin user is "1234." This may be changed to protect the Accumove2
from configuration changes by unauthorized personnel.
• The
Operator user name requires no password by default, but this may be changed.
• When the Admin user log on is completed, you will see a new button on the Run screen
labeled Machine Settings.
The Machine Settings
button will appear here