Lincoln Electric Growth Series, Инструкция по сборке

Страница: 12 / 94

Torchmate Growth Series
2
Lincoln Electric Cutting Systems equipment is designed and built with safety in mind. However, your overall
safety can be increased by proper installation ... and thoughtful operation on your part.
Safety First
1. ELECTRIC SHOCK can kill.
1.1 The electrode and work (or ground) circuits are electrically “hot” when the power
source is on. Do not touch these “hot” parts with your bare skin or wet clothing.
Wear dry, hole-free gloves to insulate hands.
1.2 Disconnect the power source before performing any service or repairs. When
the power source is operating, voltages in excess of 250 volts are produced. This
creates the potential for serious electrical shock - possibly even fatal.
1.3 Insulate yourself from work and ground using dry insulation. Wear dry gloves and
clothing. Take extra care when the work place is moist or damp.
1.4 Always be sure the work cable makes a good electrical connection with the metal
being cut or gouged. The connection should be as close as possible to the area
being cut or gouged.
1.5 Ground the work or metal to be cut or gouged to a good electrical (earth) ground.
1.6 Maintain the plasma torch, cable and work clamp in good, safe operating condition.
Repair or replace all worn or damaged parts. Replace damaged insulation.
1.7 Never dip the torch in water for cooling or plasma cut or gouge in or under water.
1.8 When working above floor level, protect yourself from a fall should you get a
shock.
1.9 Operate the pilot arc with caution. The pilot arc is capable of burning the operator,
others or even piercing safety clothing.
1.10 Also see Items 4.3 and 6.
DO NOT INSTALL, OPERATE, OR REPAIR THIS EQUIPMENT
WITHOUT READING THE SAFETY WARNINGS
CONTAINED THROUGHOUT THIS MANUAL
Think before you act— and be careful.
Electric shock
PROTECT YOURSELF AND OTHERS FROM POSSIBLE SERIOUS INJURY OR DEATH.
KEEP CHILDREN AWAY.
IF YOU WEAR A PACEMAKER, CONSULT WITH YOUR DOCTOR BEFORE OPERATING.
Read and understand the following safety highlights. For additional safety information it
is strongly recommended that you purchase a copy of “Safety in Welding & Cutting - ANSI
Standard Z49.1” from the American Welding Society, P.O. Box 351040, Miami, Florida 33135
or CSA Standard W117.2.
BE SURE THAT ALL INSTALLATION, OPERATION, MAINTENANCE, AND REPAIR PROCEDURES
ARE PERFORMED ONLY BY QUALIFIED INDIVIDUALS.
WARNING