LINCHR E-Series, Инструкция по эксплуатации и монтажу

Страница: 36 / 45

E-series AC Charger
Configuration manual V1.3 35
3.3 WLAN Station
E-series can be networked, and networked control can be achieved through a server
that supports the OCPP protocol. Currently the E-series only supports OCPP 1.6.
If you want to connect the charger to the OCPP protocol, you need to configure a
wireless router near the use of the charger, and not too far away from the charger.
After setting the charger through the following steps, the charger can automatically
connect to an available network.
⑴ The charger is in WLAN AP mode by default. When the WLAN is in AP mode,
the display light on the charger will be blue.
Fig.3-18: The WLAN display light
⑵ Follow the steps in 3.2.2 WLAN Access Point to set the "1- WI-FI Access-Point
Setting" and "2- Networking parameter Setting" in the list.
⑶ When the setting is completed, you need to press the mode switch button in the
black display area of the charger, and continuously press it for more than 3s, you
will hear a "beep" sound from the charger(About 1 second). The indicator light will
turn green at this time, which means the charger has switched to STA mode.
Fig.3-19: The WLAN switch button position
⑷ After the charger is switched to STA mode, you need to close the black cover of
the charger. After completing the above steps, the charger will automatically