5. Software Control – Lightware Device Controller
MMX8x4-HT series – User's Manual
64
Applied firmware package: v1.2.2b5 | LDC software: v2.2.1
Basic settings can be seen on the default view:
TIPS AND TRICKS: The entire view with full functionality of each channel is available by clicking on the
channel separator button. Clicking on this button once again closes the advanced layout.
6.7.1.
Panorama or Balance Settings
Panorama
property is available in microphone input settings. It defines, that
the balanced microphone input is transmitted to the left or right channel of
the balanced analog output.
Balance
parameter is available in advanced analog input, embedded audio
and advanced analog output channel.
Panorama and Balance can be set separately in each channel.
They can be configured three ways:
▪
Click on the knob and keep pressed the left button. Move the cursor up or down to set the lower or
higher value.
▪
Press + or - buttons to increase or decrease the value.
▪
Type the value into the text field.(L1-6 for the left side, R1-6 for the right side, 0 means the center.
)
TIPS AND TRICKS: Double click on the knob
restore the default value (0= center).
6.7.2.
Gain Settings
See the advanced layout to reach all adjustable properties.
Gain setting is for increase (or decrease) the input signal level, expressed in
dB.
Gain values in microphone input channel:
Min. level: -12dB, max. level: +55dB, default level: 0dB. Steps: 1dB.
Gain values in advanced analog audio channel:
Min. level: -12dB, max. level: +21dB, default level: 0dB. Steps: 3dB.
These sections can be configured three ways:
▪
Click on the knob and keep pressed the left button. Move the cursor up or down to set the lower or
higher value.
▪
Press + or - buttons to increase or decrease the value.
▪
Type the value into the text field.
6.7.3. Equalization (EQ) Settings
See the advanced layout to reach all adjustable properties.
The equalizer section is for set the proper rate of the different frequencies.
EQ frequencies in microphone input channel:
HIGH: 12kHz; HIGH-MID: 1.6 kHz, LOW-MID: 400Hz, LOW: 120Hz.
EQ frequencies in the other advanced audio channels:
HIGH: 8kHz; HIGH-MID: 1.6 kHz,
LOW-MID
: 400 Hz,
LOW
: 100Hz.
EQ parameters can be set separately in each channel, the values are between -18dB +18dB. Default level: 0dB
(zero modification in the original signal). Steps: 3dB.
These sections can be configured three ways:
▪
Click on the knob and keep pressed the left button. Move the cursor up or down to set the lower or
higher value.
▪
Press + or - buttons to increase or decrease the value. Steps: 3dB.
▪
Type the value into the text field (between -18 and +18).
TIPS AND TRICKS: Double click on the knob
restore the default value (0= center).
Equalization (EQ) setting example
This example shows how EQ settings affect to the audio signal:
▪
-18 dB was set for the
LOW
frequencies;
▪
+9 dB was set for the
LOW-MID
frequencies;
▪
+3 dB was set for the HIGH-MID frequencies;
▪
0 dB was set for the HIGH frequencies;
