LIFT-A-LOFT APX16 - G
ASOLINE
CHAPTER 2
SECTION 3
Page 14
09-26-02
(6) Remove the hydraulic hoses from the back
of the steering pump unit. (Fig 5 Item 1) Be
careful not to spill hydraulic oil in the dash.
(7) Remove the nuts from the studs on the
front side of the dash (Fig 6 Item 1) and
remove the steering pump.
Installation:
(1) Reverse the above procedure for
installation.
(2) After allowing the engine to come to operating temperature, check the fluid
level in the steering reservoir.
16. MASTER CYLINDER/BOOSTER
ASSEMBLY:
Removal: Fig 7
(1) From inside the driver’s side front
compartment, disconnect both
brake lines (1) from the right side
of the master cylinder.
(2) Disconnect the line from the
firewall mounted fluid reservoir. (2)
Note: Be ready to catch fluid from reservoir or
block end of brake reservoir line.
(3) From inside the cab, remove the brake pedal return spring, the cotter pin, and
clevis pin from the booster pushrod. Remove rubber boot (Fig 8 Item 4) from
booster pushrod.
(4) Remove the four bolts securing the master cylinder/booster assembly.
(5) Remove both hydraulic lines (Fig 7 Item 3) from booster being sure to mark
their locations.
Fig 7
1
2
3
Fig 6
1
Property of American Airlines
