LifeCore Fitness LC-1050RBs, Руководство пользователя

Страница: 9 / 30

Page | 8
Step 6: Console Assembly
Tool Needed:
Screw driver
A. Remove screws (J1) from the back of
console housing.
B. Note: To prevent wires from being
pinched, please make sure the wires are
pushed back and stored inside the central
support tube before sliding and tightening
the console.
C. Connect computer wire (E3) and heart
rate wire (E2) to console (H1).
D. As shown in Figure 6) Slide console (H1)
onto the central support tube (E). Be
aware of the wire location at all times to
prevent any pinched wires. Push any
extra wires back into housing covers.
Side the console down until it cannot be
pushed any further. Use a screw driver to
tighten the console onto the central
support tube with screws (J1).
Step 7: Back Pad Assembly
Tool Needed:
5mm Allen wrench
A. As shown in Figure 7) Assemble the back
pad (H8) onto back pad tube (G). Use a
5mm Allen wrench to tight washers (J2)
and bolts (J3).
B. Located the adjustment handle (A43) turn
the adjustment handle to the left, then
push handle onto axle (A42). (
See figure
below )