LifeCore Fitness LC-1050RBs, Руководство пользователя

Страница: 23 / 30

Page | 22
Care and Maintenance
The LifeCore 1050RBs is made from the best materials and has been tested and received a quality
control review prior to its packaging to ensure the correct parts and proper fitting of each component.
This machine was designed to limit the amount of assembly needed by a customer. The amount of
maintenance required is very little and very simple; however, a failure to implement preventative
maintenance suggestions can prevent the machine from operating as designed. The 1050RBs is
only for indoor use and should not be stored outside or damp, extremely cold or hot areas as this will
damage the unit voiding the warranty.
Always inspect hardware prior to any exercise session. Look for loose hardware, loose pedals, loose
cranks and frayed wires. Repair or replace any damaged or worn parts, tighten all loose hardware.
Rules:
¾
Never use WD-40 or any type of silicone spray to lubricate any moving parts. Use of this
type of lubrication will damage the unit’s components voiding the warranty.
¾
Always clean the machine after use.
1) Proper cleaning is important for longevity of a machine, clean the unit with a light soap
water mixture, followed by a dry towel. You can also use the light house hold cleaner
such as Windex or remove dirt and sweat. The purpose of cleaning the unit is to remove
body sweat which contains salt. Salt is the number one factor that will cause the unit to
rust and the electronics to stop working.
2) Dry the unit off with a clean towel to remove left over moisture after every use.
3) To clean pads, use a mild soap and warm water.
¾
As part of LifeCore’s normal installation and set-up process, all pedal cranks must be
tightened after 8 to 10 hours of initial riding to ensure parts are properly seated to axle. This
is standard initial “break-in” service, which must be performed after the first 8 to 10 hours of
use. Un-tightened pedal cranks may become loose, causing damage voiding the warranty.
¾
After the first 12 hours of use, check and retighten any bolts, nuts, screws, etc. making sure
that they are tight and working properly.
1) The number one service issue is loose hardware. Loose hardware can cause the unit to
tick, creak, thump, knock, etc. After the first 12 hours once all the hardware has been
tightened, the hardware should be checked every 3 months.
¾
Only use the appropriate power source, never use an adapter that is not certified for the unit,
a wrong adapter will cause the electronics to overheat and malfunction voiding the warranty.
Power Source 6v 1000mA AC Adaptor.
In the unlikely event that the 1050RBs experiences a problem, please contact LifeCore fitness for
advice toll free at 888-815-5559.