LI-COR LI7200RS, Инструкция по эксплуатации

Страница: 98 / 226

Section 3. Operation
5 In
Advanced Settings > Statistical Analysis
, all processing options are active, and you can
select them as you would do in EddyPro with no exceptions.
6
In
Advanced Settings > Output Files
, most options are active, with the following exceptions:
A
The
Set Minimal
,
Set Typical
and
Set Thorough
pre-selection buttons are deactivated,
because those pre-selections do not apply completely to the SmartFlux or SmartFlux 2 System.
B The
Full output file
and related settings are deactivated because this file will always be cre-
ated by the SmartFlux or SmartFlux 2 System in a predefined format.
C
The
Ensemble averaged cospectra and models
is unchecked and deactivated, because
this output cannot be created in the SmartFlux or SmartFlux 2 System, where .ghg files are
processed one at a time. To create those outputs, use standard EddyPro instead.
D
All full length (co)spectra outputs are deactivated. These files occupy large amounts of disk
space and are thus not allowed in the SmartFlux or SmartFlux 2 System. To obtain full length
(co)spectra files, use standard EddyPro instead.
E Processed raw data outputs are deactivated. These files occupy large amounts of disk space
and are thus not allowed in the SmartFlux or SmartFlux 2 System. To obtain those outputs,
use standard EddyPro instead.
Loading a SmartFlux Configuration File
Note: EddyPro Express settings are loaded by default so you only need to load a
configuration file if you use EddyPro Advanced settings.
To connect with the SmartFlux System or SmartFlux 2 System, see Connecting with
the SmartFlux or SmartFlux 2 System on page 3-38. To load an EddyPro Advanced con-
figuration file:
1 Create the SmartFlux configuration file.
2
Open the SmartFlux System dialog.
3
Select the
Processing Options
tab, and click the
Upload Advanced File
button. Read the
warning dialog.
3-56 LI-7200RS Enclosed CO₂/H₂O Analyzer