LI-COR LI7200RS, Инструкция по эксплуатации

Страница: 60 / 226

Section 3. Operation
Software Field Recommended Setting See Section
Anemometer > Analog
Input Settings (Analog inputs only; if the anemometer is
connected to the LI-7550) Entering
Anemometer
Information
on
page 3-22
Site Setup > CO
2
/H
2
O Analyzer
Northward separation (cm): Measured at site Entering CO2/H2O
Analyzer Information
on page 3-29
Eastward separation (cm): Measured at site
Vertical separation (cm): Measured at site
CO
2
/H
2
O Log Values Select All or Default
Flow Module (if using the LI-7200/RS)
Tube length (cm): Length of intake tube Entering the Intake
Tube Dimensions
on
page 3-32
Tube diameter (mm): Inside diameter of intake tube
Flow Rate (lpm): Set to "On"
Site Setup > CH
4
Analyzer (if using an LI-7700)
Connect to LI-7700 Select if using LI-7700 Entering LI-7700
Information
on
page 3-33
Northward separation (cm): Measured at site
Eastward separation (cm): Measured at site
Vertical separation (cm): Measured at site
CH
4
Log Values Select All or Default
Site Setup > Biomet (if using a Biomet system)
Connect to Biomet Select if using Biomet system Entering Biomet
System Information
on page 3-36
Sync clock to 7550
✓
(check this box)
SmartFlux
Connect to SmartFlux
System Click the SmartFlux button and select the unit Connecting with the
SmartFlux or
SmartFlux 2 System
on page 3-38
Data Logging Turn
ON
data logging. Begin Logging Data
on page 3-44
Table 3-2 . Checklist of mandatory and recommended EC system settings.
(...continued)
3-18 LI-7200RS Enclosed CO₂/H₂O Analyzer