LI-COR LI7200RS, Инструкция по эксплуатации

Страница: 93 / 226

l
Configure Advanced Settings (see Advanced Processing on page 3-48).
If you are using
planar-fit
, automatic
time-lag optimization
, or
in situ spectral cor-
rections
(see Using Planar Fit, In situ Spectral Corrections and Timelag Optimization in
SmartFlux or SmartFlux 2 below for details):
l
Select a planar-fit file that was generated by EddyPro using data from your site.
l
Select the automatic time-lag optimization file that was generated by EddyPro
using data from your site.
l
Select the in situ spectral corrections file that was generated by EddyPro using
data from your site.
3 Click
Create Package
in the upper right of EddyPro.
4 When prompted, name the package, select a directory and click
Create
.
The configuration file has a
.smartflux
extension.
5 Upload the SmartFlux configuration file to the SmartFlux System or SmartFlux 2 System.
See Loading a SmartFlux Configuration File on page 3-56.
Using Planar Fit, In situ Spectral Corrections and Timelag Optimization in SmartFlux
or SmartFlux 2
In order to use planar-fit, in situ spectral corrections or timelag optimization in the
original SmartFlux System or SmartFlux 2 and 3 Systems, EddyPro needs to access
the respective “planar_fit”, “spectral_assessment” and “timelag_optimization” files,
hereafter referred to as “additional configuration files”. These files contain sum-
maries of calculations performed on relatively large datasets (
Table 3-4 on the next
page) and that also apply to data to be collected in the future.
Section 3. Operation
3-51 Advanced Processing