Lexmark X548 Series, Руководство по обслуживанию

Страница: 153 / 347

Diagnostic aids
3-37
7525-63 x
Go Back
Previous
Next
NumPad Job Assist
This setting determines if a user can configure and initiate a job using the panel’s hard buttons.
To change this setting:
1. Navigate to
NumPad Job Assist
.
2. Touch or to change the setting.
3. Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Format Fax Storage
This setting allows the user to format non volatile fax storage memory.
To format the fax storage:
1. Navigate to
Format Fax Storage
.
2. Touch
Yes
to continue, or touch
No
to return to the Configuration Menu.
3. While formatting is taking place,
Formatting fax flash DO NOT POWER OFF
appears. After formatting is
complete, the display returns to the Configuration Menu.
Fax Storage Location
To change this setting:
1. Navigate to
Fax Storage Location
.
2. Touch or to change the setting.
3. Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Automatic Color Adjust
Sets the suggested number of pages which the printer should print between consecutive calibrations.
Selections are
Off
and the values between
100
and
1000
in increments of 50. The default is 500 pages.
If the printer exceeds the set value while printing a job, it completes the current job and any other jobs received
while printing the current job before it initiates a calibration. The printer does not cancel or suspend an active job
in order to perform a calibration. If a user is using the menus, including the Configuration Menu and the
Diagnostics Menu, an automatic color adjust calibration does not occur.
When an event other than page count triggers this calibration, the count that monitors the maximum number of
pages printed will be reset. For example, if the user replaces an empty toner cartridge, the next time the printer
is started, it will sense the new cartridge and perform the automatic color adjustment, even though the page
counter for Auto Color Adj is fewer than required. The Auto Color Adj page counter is then reset.
Note:
An automatic color adjust can also be initiated manually. This calibration procedure should be performed
when the MFPs internal print settings are changed. To perform and automatic color adjust, perform the following
steps:
To adjust this setting:
1. Navigate to
Automatic Color Adjust
.
2. Touch or to adjust the setting.
3. Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.