Lexmark MX910 Series, Руководство пользователя

Страница: 283 / 363

Replace paper pick rollers in [paper source], use parts and instructions in tray 1 or
tray 2 compartment [80]
Try one or more of the following:
•
Replace the pick rollers, and then touch Rollers replaced on the control panel to clear the message and continue
printing.
•
Touch Continue and replace later (Jams may continue to occur) to ignore the message and continue printing.
Replace photoconductor, 0 pages remain [84.xy]
Replace the photoconductor unit to clear the message and continue printing. For more information, see the instruction
sheet that came with the supply or see
“Replacing a photoconductor unit” on page 213 .
Note: If you do not have a replacement photoconductor unit, then see “Ordering supplies” on page 211 or go to
www.lexmark.com .
Replace unsupported cartridge [32.xy]
Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For more
information, see the instruction sheet that came with the supply or see the “Replacing supplies” section of the
User’s
Guide .
Note: If you do not have a replacement cartridge, then see the “Ordering supplies” section of the User’s Guide or
visit www.lexmark.com .
Replace unsupported photoconductor [32.xy]
Remove the photoconductor unit, and then install a supported one to clear the message and continue printing. For
more information, see the instruction sheet that came with the supply or see
“Replacing a photoconductor unit” on
page 213 .
Note: If you do not have a replacement photoconductor unit, then see “Ordering supplies” on page 211 or go to
www.lexmark.com .
Replace waste toner bottle [82.xy]
Replace the waste toner bottle to clear the message.
Restore held jobs?
Try one or more of the following:
•
From the printer control panel, touch Restore to restore all held jobs stored in the printer hard disk.
• From the printer control panel, touch Do not restore if you do not want to restore any of the print jobs.
Scanner disabled by admin [840.01]
Print without the scanner, or contact your system support person.
Troubleshooting 283