Page 10 of 13
REQUIRED TOOLS: 5/32” ALLEN WRENCH, 7/16” WRENCH, 14 MM WRENCHES (2)
STEP 8
STEP 9
Using the Legs [
A
]
that face towards the vehicle
,
remove one (1) bolt and the associated hardware from
each Leg and discard these bolts.
Install the Long Support Bar [
C
] through the
slotted
ends
of the bar using (1) 1/4”-20 x 3/4” Bolt [
P
], one
(1) 1/4” Washer [
N
], and one (1) 1/4” Nylock Nut [
M
] on
each Leg [
A
]. [Figure 19, 20 & 21].
Center the each Leg assembly and then tighten and fully secure all hand-tightened hardware from Steps 3 & 4. Check all
connections before beginning Landing Gear Operation or operating the vehicle.
SHOWN WITHOUT CARRIER FOR CLARITY
C
C
GearCage
Slot
[Figure 19]
[Figure 21]
A
A
C
[Figure 20]
Always check connections and hardware before operating the tow vehicle.
WARNING:
P
N
M
TOOLS REQUIRED: 7/16IN SOCKET & WRENCH
