Page 5 of 13
STEP 7
In the same manor as STEP 6, install the
final Leg [
A
] using the existing hardware
into the remaining bolt positions on the
passenger side of the vehicle as shown
[Figure 13 & 14].
NOTE:
Following the same procedure as
STEP 6, this Leg [
A
] is also positioned with
the
wheel’s facing towards the vehicle
.
Passenger
Driv
er
Passenger
Driv
er
[Figure 13]
[Figure 14]
A
B
A
B
Existing
Hardware
TOOLS REQUIRED: 7/16IN SOCKET & WRENCH
Existing
Hardware
Existing
Hardware
STEP 8
Place the Right Support Bar [
D
] on top of the Left
Support Bar [
E
] where the slots meet at the end of each
bar [Figure 15].
Secure the bars together with the supplied 1/4”-20 x
3/4” Bolt [
P
], one (1) 1/4” Washer [
N
], and one (1) 1/4”
Nylock Nut [
M
].
[Figure 15]
E
P
D
N
M
TOOLS REQUIRED: 7/16IN SOCKET & WRENCH
Using the wider set of Legs [
A
] that face away from the vehicle,
remove one bolt and the associated hardware from each Leg
[Figure 16 & 17].
NOTE:
Remove the bolts
that are located
furthest
away from the vehicle on
the
interior of the carrier
as
shown.
STEP 9
Passenger
Driv
er
[Figure 14]
[Figure 17]
A
Passenger
Driv
er
A
[Figure 16]
Leg Bolt
Leg Hardware
TOOLS REQUIRED: 9/16IN SOCKET & WRENCH
