Lenovo ThinkSystem NE2552E, Инструкция по применению

Страница: 495 / 574

© Copyright Lenovo 2018 Chapter 34: Simple Network Management Protocol
495
Loading a New Switch Image
To load a new switch image with the name “
MyNewImage-1.img
” into
image2
,
follow the steps below. This example shows an FTP/TFTP/SFTP server at IPv4
address 192.168.10.10, though IPv6 is also supported.
1.
Set the FTP/TFTP/SFTP server address where the switch image resides:
Set agTransferServer.0 "192.168.10.10"
2.
Set the area where the new image will be loaded:
Set agTransferImage.0 "image2"
3.
Set the name of the image:
Set agTransferImageFileName.0 "MyNewImage-1.img"
4.
If you are using an SFTP/FTP server, enter a username:
Set agTransferUserName.0 "MyName"
5.
If you are using an SFTP/FTP server, enter a password:
Set agTransferPassword.0 "MyPassword"
6.
Initiate the transfer. To transfer a switch image, enter 2 (gtimg):
Set agTransferAction.0 "2"
Loading a Saved Switch Configuration
To load a saved switch configuration with the name “MyRunningConfig.cfg” into
the switch, follow the steps below. This example shows a TFTP server at IPv4
address 192.168.10.10, though IPv6 is also supported.
1.
Set the FTP/TFTP/SFTP server address where the switch Configuration File resides:
Set agTransferServer.0 "192.168.10.10"
2.
Set the name of the configuration file:
Set agTransferCfgFileName.0 "MyRunningConfig.cfg"
3.
If you are using an SFTP/FTP server, enter a username:
Set agTransferUserName.0 "MyName"
4.
If you are using an SFTP/FTP server, enter a password:
Set agTransferPassword.0 "MyPassword"
5.
Initiate the transfer. To restore a running configuration, enter 3:
Set agTransferAction.0 "3"