Lenovo ThinkSystem NE2552E, Инструкция по применению

Страница: 405 / 574

© Copyright Lenovo 2018 Chapter 28: OSPF
405
OSPFv2 Configuration Examples
A summary of the basic steps for configuring OSPF on the NE2552E is listed here.
Detailed instructions for each of the steps is covered in the following sections:
1.
Configure IP interfaces.
One IP interface is required for each desired network (range of IP addresses) being
assigned to an OSPF area on the switch.
2.
(Optional) Configure the router ID.
The router ID is required only when configuring virtual links on the switch.
3.
Enable OSPF on the switch.
4.
Define the OSPF areas.
5.
Configure OSPF interface parameters.
IP interfaces are used for attaching networks to the various areas.
6.
(Optional) Configure route summarization between OSPF areas.
7.
(Optional) Configure virtual links.
8.
(Optional) Configure host routes.
Example 1: Simple OSPF Domain
In this example, two OSPF areas are defined—one area is the backbone and the
other is a stub area. A stub area does not allow advertisements of external routes,
thus reducing the size of the database. Instead, a default summary route of IP
address 0.0.0.0 is automatically inserted into the stub area. Any traffic for IP
address destinations outside the stub area will be forwarded to the stub area’s IP
interface, and then into the backbone.
Figure 45.
A Simple OSPF Domain
Network
10.10.12.0/24 10.10.7.0/24
Network
IF 1
10.10.7.1
IF 2
10.10.12.1
Backbone Stub Area
Area 0
(0.0.0.0)
Area 1
(0.0.0.1)